EN
ES
ID
CNMedidor de energía de carril DIN monofásico ADL200
● Rated Voltage: AC220V
● Rated Current: 10(80)A
● RS485(MODBUS-RTU) Communication
● LCD Display; 35mm DIN Rail Installation
● Multi-tariff: 4 Tariff Rates (Spike, Peak, Valley and Flat kWh)
● kWh clase 1
- Resumen
- Parámetro
- Certificados
- Preguntas y respuestas del cliente
- Contáctenos
ADL200 din rail energy meter adopts DIN35mm din rail installation with LCD display,it can measure electric parameters and has energy pulse output, RS485 communication,which has the advantages of small size, high precision, good reliability and convenient installation.]
① Enter-wire
② Marca
③ Panel
④ Up Button
⑤ Down Button
⑥ Pluse Output
⑦ Model
⑧ Botón de configuración
⑨ Out-wire
clave
Pantalla
Dimensiones
Note：The torque of direct connect should not be greater than 4.0N·m.
Nuestra red
INSTALACIÓN
| Voltaje de entrada | Voltaje de referencia | AC 220V |
| Frecuencia de referencia | 50Hz | |
| Consumo de energía | ||
| Corriente de entrada | Corriente basica | 10A |
| Corriente máxima | 80A | |
| Corriente de arranque | 4‰Ib | |
| Consumo | ||
| Rendimiento de medición | Precisión de medición | 1 class |
| Rango de medida | 000000.00 ~ 99999999kWh | |
| Precisión del reloj | Error≤0.5s/d | |
| pulso activo | Ancho de pulso | 80±20ms |
| Constante de pulso | 1000imp / kWh | |
| Comunicación | Interfaz | RS485 (A+, B-) |
| Modo de conexión | Conductores de par trenzado blindados | |
| Protocolo | MODBUS-RTU | |
Preguntas y respuestas del cliente
-
Respuesta
Switch the meter display interface to the power (active power P, power factor λ) interface, and check whether the power display is negative or not.And whether the power factor is between 0.9-0.95, and then check whether the incoming and outgoing wires of the current signal wire are connected reversely (that is, the current The incoming wire must be the same as the incoming wire end of the meter), and consistent with the wiring diagram on the meter.
casarse 31 de agosto de 2022
-
Respuesta
1. The voltage value between the communication output A and B of the measuring instrument should be between +(4.4-4.5)V . 2. Check whether the communication wiring method is correctly wired according to the wiring diagram (that is, the communication terminal A/B of the instrument must be connected with Corresponding to communication serial port A/B);
casarse 31 de agosto de 2022
